MOP-003 Overhead Shoulder Cannon Set 01 1/144

This is a 3D printed resin accessory designed for 1/144 scale gunpla kits

Some modification to connector required to work with select model kits (2 peg connection)

All parts will require some cleanup, gluing & some paint to get a finished look.

• MOP-003 Short Cannon Barrel Resin Print [x2]
• MOP-003 Shoulder Cannon Body Resin Print [Left & Right]
• MOP-001 Standard Backpack Resin Print
• HWS Backpack Attachment Arm Resin Print [Left & Right]
• HWS Barrel Cap 01 Resin Print [x2]
• HWS Thrusters 001 Resin Print [x2]

Due to the nature of Resin 3D Printing, parts come with layer lines and leftover support knick knacks.

You can sand the layer lines down and use tweezers or a knife to cut off left over supports. For small holes, fill with any type of hobby putty.

[WARNING] Resin is a toxic material when airborne, be in a well ventilated area & wear a proper respirator when sanding or consider wet sanding pieces.

Please refer to our Precautions & Guidelines sheet before working on this kit

Most resin parts can be repaired using super glue or CA glue.

Please do not use plastic cement as these are resin and they will not bond